Set up a Wildlife Network Base
An open listening station on a Raspberry Pi: flash the card, power on, set it up from your phone.
A Wildlife Network Base is an open station you build yourself: a Raspberry Pi 4 or 5 with a USB microphone (optionally a 4G modem and a solar battery) in a weatherproof box. It identifies birds on the spot with BirdNET-Go and sends what it hears to Wildlife Network. Without internet it keeps its detections until it can send them, or until a phone carries them out. It is still in testing.
What you need
- A Raspberry Pi 4 or 5 and its power supply.
- A microSD card of 32 GB or more.
- A USB microphone. The Base picks the first USB microphone it finds.
- For outdoors: a weatherproof box, and a 4G modem or a Wi-Fi network in reach.
Set it up
- Download the newest Wildlife Network Base image and its checksum from the releases page, and check the checksum.
- Write the image to the microSD card with Raspberry Pi Imager (choose Use custom, and skip Imager's customisation).
- Put the card in the Pi and power it on. The first start takes about 2 minutes.
- On your phone, join the Wi-Fi Wildlife Network-XXXX with the password on the label. No label? The name, password and setup code are in the file wildnetwork-setup.txt on the card.
- Open the BirdEcho app and add a Base, or open http://10.42.0.1 in a browser. Give the station a name and its location, and choose how it reaches the internet.
- Tick Test station while you try it out at home. Its detections stay off the public map. Untick it once the Base is in its real place.
Tip: Already running Raspberry Pi OS? You can install the Base software with one command instead of flashing the image: see the Base guide on GitHub.
With the BirdEcho app
- See what the Base hears in the Feed, and its health on the Base page: microphone, temperature, signal, and a note when it has not reported for over an hour.
- No Wi-Fi or SIM where the Base is? Open its page in BirdEcho, choose Collect detections and join the Base's Wi-Fi. The phone keeps the detections and uploads them once it has internet.
- Away from the Base's Wi-Fi, the Feed shows its detections from Wildlife Network, marked From Wildlife Network. Recordings play only on the same Wi-Fi as the Base.
- Moved the Base? On the same Wi-Fi as the Base (or its own Wi-Fi), open its page in BirdEcho and choose Change location, or use the setup page. Earlier detections keep their old place; new ones use the new location.
- The Base sets its clock's time zone from its location (Base 0.2.2 and later), so detections show local time. To choose another time zone, use Time zone under Advanced on the setup page.
Privacy
The Base rounds its location to about 1 km before anything leaves it. Its health reports (temperature, storage, microphone, signal) are private to you and carry no audio. BirdNET-Go's settings on the Base are protected by a password; reading detections stays open on the Base's own network, so the BirdEcho app can show them.
Still stuck, or is something here wrong? Tell us and we will help, and fix the guide.